Lotion Pump Manufacturer introduces the method of measuring the length of nozzle, lotion pump and hand washing pump:

1. Sprinkler head: bayonet (half bayonet aluminum, full bayonet aluminum), the screw is all plastic, but some are covered with a layer of aluminum cover and a layer of anodized aluminum. Nozzle: 15/18/20 MM all plastic is also divided into 18/20/24

2. Lotion pump: It is divided into vacuum and suction tube, both of which are screw ports. A layer of anodized aluminum can also be covered on the large screw cap and head cap. Divided into two kinds of sharp beak and duckbill. Lotion pump: 18/20/24 MM

3. Hand-washing pump: The caliber is too large, all with screw mouth. A layer of anodized aluminum can also be covered on the large screw cap and head cap. Generally, the steps are threaded, and the ones without steps are the left and right knobs. Hand washing pump: 24/28/32(33) MM

Length measurement: the length of the sub-pipette (from the gasket to the end of the hose or the length of the FBOG). Exposed length. And the length measured under the big hood (equal to the length from the bottle shoulder to the bottom of the bottle).

Through the above introduction, Mist Pump Wholesaler hopes that you can simply refer to the content of this article in future use.