Among the kilometers of the development trend of stainless steel chains, in addition to the development trend of chain products and the emergence of new materials, the efficiency of stainless steel chains has been improved,...

The reasons for the inefficiency of Transmission Chain fatigue are:
1. The chain bears too much load during operation,
2. Lead to uneven bearing capacity, which is very easy to crack or be extruded.
3. Under normal...

Transmission Chain manufacturer introduces how to maintain the chain:
1. The tightness of the sprocket should be appropriate. Too tight will increase power consumption and the bearing will wear out easily. If the sprocket...

Reasons affecting the quality of Transmission Chain :
1. The size and weight of the industrial rotating chain: the iron chain can be fully immersed in the zinc solution at a time to reach a uniform galvanized film. If it is...

3 ways to judge the quality of Roller Chain :
1. The quality of the chain can be distinguished from the appearance
It mainly depends on the deformation of the chain, as well as the current cracks and corrosion. The other is...

Roller Chain Manufacturers introduced that the sprocket must pay attention to safety issues during the production process. Safety issues are the key. Safety during production means less loss, which is better for us. Safety...

Under normal circumstances, Drive Chain is still relatively difficult to rust, but if rust occurs during use, there are often some special reasons. Here Drive Chain manufacturer will introduce to you.
1. Failure to strictly...

Drive Chain Manufacturers Introduction According to different uses, chains can be divided into three categories: lifting chains, traction chains and drive chains. Lifting chain is mainly used for lifting heavy objects in...

The structure of Roller Chain :
The outer chain plate and the pin shaft, the inner chain plate and the sleeve are respectively connected by an interference fit. The gap between the sleeve and pin, sleeve, and roller is...

Drive Chain Manufacturers introduces common heat treatment methods for suspension chains: annealing, normalizing, quenching, tempering, carburizing, nitriding, carbonitriding, and boronizing.
1. Annealing, heat the workpiece...