Reasons affecting the quality of Transmission Chain :

1. The size and weight of the industrial rotating chain: the iron chain can be fully immersed in the zinc solution at a time to reach a uniform galvanized film. If it is too long or too wide, it will be necessary to dip the worker twice. The appearance of the zinc layer will appear rough, too thick, etc. Others, such as the weight of the iron chain is too heavy, how much the transmission chain is, and those who exceed the load of the galvanizing equipment will make it difficult to work;

2. Combination of dissimilar metals: For example, the industrial rotating chain is a combination of iron and copper, tin, lead and other non-ferrous metals. During hot dipping, the dissolution of this non-metal will change the arrangement of the zinc film. Another example is the combination of new and old iron chains. During pickling, new raw materials are prone to excessive pickling;

3. Chain pollution: such as paint pollution, special grease pollution, etc., it is not easy to remove in general alkaline degreasing liquid. At this moment, it is necessary to use special solvents to eliminate or use incineration, sandblasting, etc., where is the conveying chain good? , Make the cost increase and work hard. In addition, the removal of welding slag such as welding touch is also appropriate and important.

Through the above introduction, Agricultural Chain Manufacturers hopes that you can simply refer to the content of this article in future use.