When the stainless steel clad plate cylinder is made, the requirements for the control of the misalignment are much stricter than those of ordinary carbon steel or low-alloy steel. Controlling the misalignment of the stainless steel clad plate not exceeding the standard is a key to ensuring its strength and corrosion resistance. Below, China Color Coated Aluminum Coil Factory introduces the details of the use of composite panels:

(1) Calculate the unrolling length strictly according to the "Accurate Solution of Unrolling Size of Cylinder Blanking", and ensure that the actual uncutting size is accurate.
(2) Ensure the rounding quality of the barrel section and control the roundness.
(3) For composite panels with a wall thickness greater than 20mm, the indenter should be pre-bent, and then rounded.
(4) The dimensioning of the groove form is based on the cladding to ensure that the amount of misalignment does not exceed the standard.
(5) The ring seam pair adopts the "circular radial finding tool" to ensure the roundness of the cylinder and the quality of the pair.
(6) When the head and the cylinder are paired, first ensure their respective roundness, and then match the circumference of the cylinder with the circumference of the head to ensure the quality of the pairing of the head and the cylinder.
(7) The cladding shall be used as the benchmark during group alignment to prevent the misalignment of the cladding from exceeding the standard.

Through the above introduction, China Galvanized Steel Composite Panel Factory hopes that you can simply refer to the content of this article in future use.

https://www.alubang.net/