Stainless Steel Faucets Manufacturers describes how to install pull-out faucets:

1. Check the accessories first, then take out the switch split body of the faucet, screw out the nut and washer, and insert it from the right mounting hole, repeat the main body according to the procedure just now, and then insert the faucet body from the left mounting hole .

2. Put the main body of the faucet and the split anti-skid ring and washer back from the bottom end, and then screw on the nut. Remember not to put these small accessories in disorder, it will be troublesome if you lose it.

3. Take out the sealing rubber gasket and tighten it into the mounting hole together with the small nut at the end of the short shower hose.

4. Connect the two hot and cold water inlet pipes, and then connect the water inlet pipe to the angle valve.

Through the above introduction, Stainless Steel Faucet Wholesaler hopes that you can simply refer to the content of this article in future use.

https://www.afastainlesskb.com/