Do you know how to fix a foam soap dispenser when it does not work? Keep reading this article, you will know the exact operation procedures.
　　1: Unscrew the cap from the Lotion Dispenser Pump whloesales and remove the dispenser pump assembly. Wipe off the dispenser tube with a paper towel, then immerse the entire assembly, including the pump and the tubes, in warm water. Leave it for 5 minutes. The water dissolves congealed soap. If the pump wasn't dispensing soap, this procedure may fix the issue. If the spring is broken, this procedure cleans the pump and makes it easier to disassemble.
　　2: If your soap dispenser still isn't working, you may need to do a little more work. Unscrew the pump reservoir from the spout if you can. Inexpensive pumps that come on shampoo and soap bottles are often fused and don't come apart. Separate the reservoir from the spout and remove the spring. Replace the spring with an identical one.
　　3: You can also replace the dispenser tube if it's too short or it's kinked. You can usually pull it off of the reservoir tube. You should be able to find a replacement at a hardware store, in the section for plastic tubing. Reassemble the pump and clean it out by pumping hot water through it. Screw it back onto the soap container once you're sure all clogs have dissolved.
　　4: If none of these procedures fix your pump, it's probably because the internal seals are compromised. If so, don't bother trying to repair it. Even if you could, it's easier and more reliable to just get a new pump.
　　We offer all kinds of cosmetic packaging, such as Fine Mist Sprayer Pump for sale, please consult us if you have any questions. https://www.kerrysprayer.com