Lavatory Cabinet Manufacturers tells how to save water?

1. Don't be too strong when boiling water. In real life, the impact pressure of water flow is far greater than the ability of the water-saving dragon to withstand, just like the ceramic valve body faucet, it can meet the water pressure of 0.1MPa and the pipe diameter below 15mm, and the maximum flow rate does not exceed 9 liters/min. For body faucets, when the water pressure exceeds 0.1MPa, the flow will increase with the increase of the water pressure. The 0.2MPa water pressure generally reaches 14~18 liters/min. Most of the water supply pressure is 0.1MPa-most of them are above 0.2MPa, so it is in use. Don't make the switch too hard for the water faucet. Otherwise, that one won't be too long.

2. Once the water leaks, repair the water-saving faucet immediately. This kind of water-saving faucet of qualified quality has a good sealing effect when it is newly put into use, but the ceramic seal is sensitive to hard impurities such as sand and stones in the water, and the sealing surface is easy to wear and damage-the sealing surface is worn out, and water leakage will occur after damage ¤ and After the water leaks, the amount of water leaking increases immediately, and a linear flow will soon be formed, so in order to make your faucet longer.

Through the above introduction, Stainless Steel Faucets Manufacturers hopes that you can simply refer to the content of this article in future use.

https://www.afastainlesskb.com/