Roller Chain Manufacturers introduced that the sprocket must pay attention to safety issues during the production process. Safety issues are the key. Safety during production means less loss, which is better for us. Safety issues It can’t be ignored, this can have a better effect.
After production, products need to be tested, and product testing needs everyone to pay attention to, testing can reduce the failure rate, for us, it is possible to obtain better products, and it is also very good in market sales. of.
In the process of using the sprocket, its tightness should be appropriate. Too tight will increase power consumption and the bearings will be easily worn; too loose sprocket will easily jump and fall off the chain. The tightness of the sprocket is: lifted or pressed down from the middle of the sprocket, which is about 2%-3% of the center distance between the two sprocket. The sprocket should not swing or skew when installed on the shaft.
When the sprocket is severely worn, the new sprocket and the new sprocket should be replaced at the same time to ensure good meshing. The new sprocket is too long or stretched after use, which is difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number. The sprocket should be filled with lubricant in time during work. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place.

Through the above introduction, Drive Chain Manufacturers hopes that you can simply refer to the content of this article in future use.