Due to the practical characteristics of the bolt itself and other problems, the outer diameter of the threaded tooth is small, and there are ordinary bolts, and when the outer diameter is small, the outer diameter of the tooth will slide. Nowadays, the thread sliding solution has been improved, the use of threads has been standardized, the appropriate threads have been selected, the appropriate threads have been customized or purchased, and high-quality bolt materials have been used, which makes the threads more rigid, and Hex Nut Manufacturers have been assembled High-strength bolt connection is used, and the high-strength bolt connection pair is assembled at both ends.

Regardless of whether the processing temperature of the product is too low or the heating temperature is too low, the springback cannot be reduced well after bending. If the heating temperature is too high, there are too many workpieces with surface oxides, which will affect the surface quality of the workpiece. After quenching, the workpiece may be deformed. In order to reduce deformation, use oil as cooling water during quenching, choose a slower cooling rate and reduce the internal stress of the workpiece to reduce the deformation of the workpiece after quenching. The production practice of the effect of the above-mentioned processing technology is completely feasible. With the advancement of science and technology, the requirements for materials are getting higher and higher.

Standard parts have their own requirements for the production of raw materials, most of which are made of steel wire or steel. They can be used to produce studs and other fastening parts, especially according to the strength requirements and material corrosion resistance requirements under working conditions. The materials that meet the applicable requirements are selected according to the relevant national standards. The length of the screw is not enough and the hardness is not enough to withstand the corresponding torque. The torque that cannot withstand the strength of the screw and the appropriate torque result in insufficient combination with each other.
Through the above introduction, 2h Hex Nut Manufacturers hopes that you can simply refer to the content of this article in future use.

https://www.ydfastener.com/