Today, stainless steel faucets manufacturers to share how to correctly in the valve core.

1. How to remove the old spool?
Method 1: first close the total water valve, and then the faucet handle hands have a red and blue 8 mm mark, buckle down, with a word screw counterclockwise loosen the fixing screw, take off the handle, open the faucet spool with a wrench, open the upper part of the cover with a wrench, take out the ceramic spool.

Method two: first close the total water valve, you can use the screw inserted under the handle of the faucet, pry up the left and right sides, to one side pry, to slowly, uniform and stable force, so you can take off the valve core.

Method three: first close the total water valve, the right handle on the blue cover unscrew, screw with a cruciform screw to loosen the inside, take off the handle, the valve core, and then use a wrench to screw down the valve core.

2. How to replace the new spool?

Remove the spool, you will see the bottom of the spool with a circle of blue rubber.
General custom is the left spool bottom is red rubber, and the right spool is blue rubber.
So change the right of the valve core, or to use the blue rubber valve core, the valve core installed, the handle inserted, adjust the direction of the hand.
Insert the handle and adjust the direction of your hands. Turn off the water when the handle is on both sides, and the direction of standing is boiling water.
Install the screw and cover the right blue cover so that the new spool is replaced.

information about stainless steel faucets : https://www.afastainlesskb.com/product/stainless-steel-faucets/