The most troublesome part of fiber is that it is very fragile, and a slight squeeze or bend signal is broken. Fiber optic connectors are fiber optic lines and optical cat connectors that are not as durable as the old phone line connectors we used before. The fiber optic quick connector is easily damaged and requires a $100 maintenance fee per replacement. In fact, friends with better hands-on ability can try to make their own connectors, and can greatly reduce the cost of replacement. Below, the Fiber Closure manufacturer will tell you how to install a fiber optic quick connector.

Fiber optic quick connectors are installed in both hot and cold connections. Hot melt adhesives require a hot melt machine, and high-tech control is not suitable for laymen. Here, I will introduce you to the cold connection method. We only need one fiber cutter. Many great gods can only connect connectors to needle-nosed pliers. This high-tech method is not recommended.

The first step is to prepare the tool. We will be ready to prepare the cutter and quick connector, open the previous connector and see if there is an embedded fiber break inside. If the fiber is not broken inside, we only need to carefully remove the fiber, then place the newly made fiber head into it and place it on the bite cover. In most cases, the fiber pre-embedded wire breaks inside the connector. This is a connector that can no longer be reused and needs to be replaced with a new one.

The second step is to make an adapter. Let us first look at the structure of the connector: a blue outer casing with a cable gland on the black fiber cooler and a nut at the end. After understanding the structure of the fiber optic connector, let's make a fiber optic connector. Pull the fiber out of the skin. Note that the fiber optic cable cannot be bent, otherwise it will not be used. After removing the skin, we screwed the lid onto the fiber and left it behind.

Strip the outer skin of the fiber with a bare wire larger than 22 mm, as we will use a 22 mm fiber head for a period of time. After stripping, we have to use a fiber cutter here, which is inexpensive and easy to buy. Place the fiber tip on the cutter to cut more than 22 mm. After completing the above steps, prepare a standard fiber optic connector.

The third step is to connect the adapter to the fiber. The tip of the fiber is inserted into the hole in the back of the connector, and the insertion depth is a slight bend of the fiber. Do not use excessive force when inserting to avoid rupture. Next, cover the quick connector cover to secure the fiber connector, then tighten the fiber quick connector nut to secure it.

The installation steps for the fiber optic quick connector are not complicated, but the installer's technical requirements are high. Fiber optics have a high level of cleanliness and can fail or be interrupted if it gets dirty during the installation process. On the Internet, it is not feasible to see friends using nails to peel and cut threads. This will cause the fibers to be dyed. If the fiber optic quick connector you are making does not work, it may be because the fiber is dirty or damaged during installation.

information about Fiber Closure : https://www.greentelftth.com/product/fiber-optical-splice-closure/dome-fiber-optical-splice-closure/